Fencing
A fence does three jobs at once — marks the line, keeps what you want in, and keeps what you do not want out. Which of the three matters most changes the height, the spacing and the material, and it is worth settling before anyone orders cedar.
We set posts for a wet climate and for the freeze that arrives most winters. Almost every fence that fails around here fails at the post, below ground, years before the boards give out.
Based in Lynnwood, WA. See all our landscaping services in Lynnwood.
What This Covers
Swipe to see all eight →
01
Cedar, pressure-treated, or a mix, built on site rather than dropped in as pre-made panels. The line gets walked and marked first, posts are set to depth, then rails and boards — so the fence follows the ground instead of fighting it.
See this work02
Six-foot solid cedar is the standard here, and good cedar handles the damp far better than the budget alternatives. Board-on-board or a tight butt joint, depending on how much screening you actually want and how much airflow the run needs.
See this work03
Split boards, sagging rails, leaning sections and gates that no longer latch. We repair fences we did not build, and we say so plainly when the posts have gone and another round of repairs will cost more than replacing the run properly.
See this work04
Taking the old fence out, pulling the old footings, and hauling it away before the new line goes in. Leaving the previous concrete in the ground is the usual reason a replacement ends up crooked or off the line.
See this work05
The gate is the part that breaks, because it is the only part that moves. Braced frames, posts sized for the swing, and hinges and latches rated for the actual weight rather than whatever came in the kit.
See this work06
Holes dug below the frost line, gravel at the base so the post is not standing in water, and concrete crowned to shed rain rather than hold it. This is the whole difference between a fence at eight years and a fence at twenty.
See this work07
Racked to follow the slope, or stepped down it — the choice changes both the look and the gap left underneath. On steeper ground the fence sometimes belongs on top of a short retaining wall, which we build as well.
See this work08
Where the line actually runs, how tall you are allowed to build on it, and what the setback is on a corner lot. The rules differ by city, and a fence in the wrong place is an expensive thing to move afterwards.
See this workHow We Approach It
The boards and rails are what you see, and they are rarely what fails. In this climate a fence goes when water sits around the post and rots it at ground level, or when the footing was never deep enough to hold through a freeze and a wet spring behind it.
Fencing goes in before the planting and the finish grading, never after. Digging post holes through a new lawn or a finished bed means repairing both, and moving posts and panels down a narrow side yard is far easier while the ground is still bare.
The same applies to irrigation. We check for sprinkler lines and drain runs before setting posts — a post driven through a mainline is a cheap thing to avoid and an expensive thing to find later.
CONTACT US
If you would like to request service or a consultation, please contact us by phone, email or use the form below.
Where We Work
From our base in Lynnwood we work across thirty cities in both counties. Permit rules, water districts and freeze dates change from one city to the next, and we check the local rules before any work starts.
How It Works
01
Send the form or call (425) 648-9443 and tell us what you need. Photos of the problem area help more than anything else you can send us.
02
We visit the property, find the real cause or the best layout, and give you a clear, written price before any work starts.
03
Our own crew does the work and checks it before we leave, and we stay reachable afterwards for anything that needs adjusting.
Free consultation across Edmonds, Lynnwood and Mountlake Terrace, WA.
