Sprinkler Design
Most sprinkler problems start with a bad layout. We design your system around your yard, your plants and your water pressure, so it works right from day one.
Based in Lynnwood. Licensed, bonded and insured. Every install backed by the Grizzly 18-month warranty.
What's Included
Swipe to see all eight →
01
We measure your lawn, beds and slopes so the plan fits your real yard.
See this work02
We test your pressure and flow so every zone gets enough water.
See this work04
Rotors, sprays and drip matched to each area for even coverage.
See this work05
Beds, shrubs and planters watered at the roots, not the leaves.
See this work06
Timers set for Lynnwood's wet springs and dry summers, not a one-size schedule.
See this work07
Dry spots and soggy corners fixed by fixing the layout, not patching parts.
See this work08
A clear layout and price, so the install goes fast and nothing is guessed.
See this workWhy Grizzly
Dry spots, soggy corners and high water bills usually come from the design, not the parts. We plan every zone before the first trench.
A good design also plans for what comes next. If you're adding a patio, new beds or a play area later, we lay out the lines and valves so the system can grow without tearing out what's already in the ground.
Once your system is in, we run every zone with you and show you how to use the controller.
Already have a system that never worked right? We can redesign it, reusing good pipe and valves where they still work and changing only the zones that cause dry spots or runoff.
Every install comes with the Grizzly 18-month warranty. If something we installed fails, we come back and fix it.
CONTACT US
If you would like to request service or a consultation, please contact us by phone, email or use the form below.
Common Questions
A design divides your yard into zones based on sun, shade, slope, and plant type so every area gets the right amount of water. Without one, you get dry spots, overspray onto sidewalks, and wasted water.
It depends on your water pressure and flow rate. Grizzly measures both before designing, then sizes each zone so every head gets full pressure. Rotors and spray heads should never be mixed on the same zone because they apply water at different rates.
A good design starts with your water pressure, flow rate, yard measurements, sun and shade areas, slopes, and plant types. Grizzly gathers all of this during an on-site visit.
Yes. Pipe can be installed through narrow trenches or pulled underground with minimal disruption. Most lawns fully recover within a few weeks.
Yes, for garden beds, shrubs, and trees. Drip delivers water directly to the roots with almost no waste. Lawns still use rotors or spray heads.
Where We Work
From our base in Lynnwood, we design and install sprinkler systems across Snohomish and King County.
Alderwood, WA
Bothell, WA
Edmonds, WA
Everett, WA
Lynnwood, WA
Marysville, WA
Mountlake Terrace, WA
Mukilteo, WA
North Creek, WA
Snohomish, WA
Auburn, WA
Bellevue, WA
Clyde Hill, WA
East Renton Highlands, WA
Federal Way, WA
Hunts Point, WA
Issaquah, WA
Kenmore, WA
Kent, WA
Kirkland, WA
Maple Valley, WA
Medina, WA
Mercer Island, WA
Newcastle, WA
Redmond, WA
Renton, WA
Sammamish, WA
Seattle, WA
Shoreline, WA
Woodinville, WA
How It Works
01
Call (425) 648-9443 or send the form. Tell us about your yard.
02
We walk your yard, check your water pressure and give you a clear price before any work starts.
03
Our own crew installs the system, tests every zone with you and backs it with an 18-month warranty.
Free consultation across Kirkland, Lynnwood and Redmond, WA.
